Show Utilization - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

show utilization

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
show utilization [ detail ] [ filter ]
Command introduced before JunosE Release 7.1.0.
detail keyword added in JunosE Release 8.0.0.
Displays information about the resources that the installed modules consume and forces
the router to release available memory on the SRP module. The detail keyword displays
additional information about the average CPU utilization percentage calculated over
5-second, 1-minute, and 5-minute intervals for each module installed in the router.
NOTE: When you issue this command, the router releases available memory
on the SRP module immediately, but takes a few seconds to display the
resources.
detail—Displays the average CPU utilization percentage for 5-second, 1-minute, and
5-minute intervals for each installed module
filter—See Filtering show Commands on page 4
Privileged Exec
Chapter 7: S Commands
1169