Slot Enable - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

slot enable

Syntax
Release Information
Description
Options
Mode
1182
slot enable slotNum [ subsystem ]
Command introduced before JunosE Release 7.1.0.
Enables the module installed in the specified slot. You cannot use this command on a
slot that contains a primary SRP module. There is no no version.
slotNum—Number of the selected slot in the router; for ERX7xx models, a number in
the range 0–6; for ERX14xx models, a number in the range 0–13; for the ERX310 router,
a number in the range 1–2; for the E120 router, a number in the range 0–5; for the E320
router, a number in the range 0–16
subsystem—Type of subsystem on the E320 router; use when the specified slotNumber
is a slot that contains an SRP module
srp—Indicates the SC on one or both SRP modules; specify this keyword to enable
only the portion of the SC on the individual SRP module
fabric—Indicates the portion of the switch fabric on the SRP modules; specify this
keyword to enable only an individual fabric slice
Global Configuration
Copyright © 2010, Juniper Networks, Inc.