Transform - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

transform

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
transform transform0
[ transform1 [ transform2 [ transform3 [ transform4 [ transform5 ] ] ] ] ]
no transform
Command introduced in JunosE Release 7.3.0.
Specifies the eligible transforms for this profile for IPSec source address negotiations.
You can specify up to six transform algorithms for this profile. The no version resets the
transform to the default, esp-3des-sha1.
transform0 through transform5—AH or ESP transform
IPSec Tunnel Profile Configuration
Chapter 8: T Commands
1333