Table of Contents
Advertisement
traps
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] traps { all | [ virtIfStateChange | nbrStateChange | virtNbrStateChange |
ifConfigError | virtIfConfigError | ifAuthFailure | virtIfAuthFailure | ifRxBadPkt |
virtIfRxBadPkt | txRetransmit | virtTxRetransmit | originateLsa | maxAgeLsa |
ifStateChange ]* }
Command introduced before JunosE Release 7.1.0.
Specifies OSPF trap settings. The no version removes all OSPF trap settings or any
specified traps.
all—Enables all OSPF traps
virtIfStateChange—Sets a trap to indicate a state change on an OSPF virtual interface
nbrStateChange—Sets a trap to indicate a state change on a nonvirtual OSPF neighbor
virtNbrStateChange—Sets a trap to indicate a state change on a virtual OSPF neighbor
ifConfigError—Sets a trap to indicate a configuration mismatch with a nonvirtual
neighbor
virtIfConfigError—Sets a trap to indicate a configuration mismatch with a virtual neighbor
ifAuthFailure—Sets a trap to indicate an authentication failure on a nonvirtual interface
virtIfAuthFailure—Sets a trap to indicate an authentication failure on a virtual interface
ifRxBadPkt—Sets a trap to indicate that a packet has been received that cannot be
parsed
virtIfRxBadPkt—Sets a trap to indicate that a packet has been received on a virtual
interface that cannot be parsed
txRetransmit—Sets a trap to indicate that a packet has been retransmitted on a
nonvirtual interface
virtTxRetransmit—Sets a trap to indicate that a packet has been retransmitted on a
virtual interface
originateLsa—Sets a trap to indicate that a new LSA has been originated by this router
maxAgeLsa—Sets a trap to indicate that an LSA in this router LSDB has reached MaxAge
ifStateChange—Sets a trap to indicate a state change on an OSPF interface
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Router Configuration
Chapter 8: T Commands
1337
Advertisement
Table of Contents
