tunnel local-identity
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel local-identity { address ipAddress | subnet ipAddress subnetMask |
range ipAddressLow ipAddressHigh }
no tunnel local-identity
Command introduced before JunosE Release 7.1.0.
Specifies the local identity of the IPSec tunnel. The no version removes the local endpoint
and sets the default identity, which is subnet 0.0.0.0 0.0.0.0.
ipAddress—IP address of the local identity
subnetMask—Mask applied to the subnet IP address of the local identity
ipAddressLow—Lower bound of the range of IP addresses of the local identity
ipAddressHigh—Upper bound of the range of IP addresses of the local identity
Interface Configuration
Chapter 8: T Commands
1351