Slot Accept - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

slot accept

Syntax
Release Information
Description
Options
Mode
1180
slot accept slotNum [ subsystem ]
Command introduced before JunosE Release 7.1.0.
Erases from NVS the type and configuration of the previous module in the specified slot,
and allows you to configure a new module. Issue this command after you have installed
a different type of module in a slot. You can use this command only when the state of
the module in the slot is not present or disabled (mismatch). There is no no version.
slotNum—For ERX7xx models, a number in the range 0–6; for ERX14xx models, a
number in the range 0–13; for the ERX310 router, a number in the range 1–2; for the
E120 router, a number in the range 0–5; for the E320 router, a number in the range 0–16
subsystem—Type of subsystem on the E120 and E320 routers; use when the specified
slotNumber is a slot that contains an SRP module
srp—Indicates the SC on one or both SRP modules; specify this keyword to accept
only the configuration of the portion of the SC on the individual SRP module
fabric—Indicates the portion of the switch fabric on the SRP modules; specify this
keyword to accept only the configuration of an individual fabric slice
Global Configuration
Copyright © 2010, Juniper Networks, Inc.