Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 1233

Copyright © 2010, Juniper Networks, Inc.
ldp—LDP traps
link—SNMP linkUp and linkDown traps
log—System log capacity traps
mobileIpv4—Mobile IPv4 traps
mplste—Mplste traps
mrouter—Mrouter traps
ntp—E Series router proprietary traps
ospf—OSPF traps
packetMirror—Secure packet mirroring traps; visible only if packet mirroring is enabled
pim—PIM traps
ping—Ping operation traps (in disman remops MIB)
radius—RADIUS authentication and authorization servers
routeTable—Maximum route limit and warning threshold traps; when this trap is
generated, the actual value of the exceeded warning threshold is displayed
sonet—SONET traps
snmp—SNMP coldStart, warmStart, link, and authenticationFailure traps
traceroute—Traceroute operation traps (in disman remops MIB)
vrrp—VRRP traps
snmp—Specifies the SNMP coldStart, warmStart, and authenticationFailure traps
authentication—Specifies the SNMP authenticationFailure trap
trapFilters—Specifies the trap severity level at a global level; if the per-category trap
severity level is not set for a particular category, this setting is applied to that category
trapFilter—Minimum severity level for filtering traps at a global level or for a specified
category
emergency—Severity level 0
alert—Severity level 1
critical—Severity level 2
error—Severity level 3
warning—Severity level 4
notice—Severity level 5
Chapter 7: S Commands
1191