Trigger Delay - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

trigger delay

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
trigger delay msec delayTime
no trigger delay
Command introduced before JunosE Release 7.1.0.
Specifies the time duration used to determine when a SONET/SDH defect at the line or
section layer becomes an alarm. The no version restores the default setting, 2500
milliseconds.
delayTime—Time in the range 0–2500 milliseconds
Controller Configuration
Chapter 8: T Commands
1339