Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 1315

table-map
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
table-map mapTag
For removing route maps for IS-IS IPv6 only:
no table-map
For removing route maps for all other cases:
no table-map [ mapTag ]
Command introduced before JunosE Release 7.1.0.
Applies the specified route map to all BGP, IS-IS, OSPF, or RIP routes about to be added
to the IP routing table. The no version halts application of the route map.
mapTag—A string of up to 32 alphanumeric characters that specifies the name of the
route map; for each protocol, the route map can set only the following values:
BGP—Distance, IP next hop, level, metric, metric type, route type, and tag values
IS-IS—Distance, level, metric, metric type, origin, preference, route type, and tag
values; IS-IS IPv6 supports only a single route map
OSPF—Distance, metric, metric type, route type, and tag values
RIP—Distance, metric, and tag values
Address Family Configuration (BGP, IS-IS, RIP), Router Configuration (BGP, IS-IS, OSPF,
RIP)
Chapter 8: T Commands
1273