Tunnel Group - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

tunnel group

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
tunnel group tunnelGroupName
no tunnel group
Command introduced before JunosE Release 7.1.0.
Assigns the specified tunnel group to the domain map. The no version deletes the tunnel
group.
NOTE: By default, no tunnel group is assigned to the domain map. You can
assign a tunnel group to the domain map only if tunnels are not currently
defined for the domain map in Domain Map Tunnel mode.
tunnelGroupName—String of up to 64 characters (no spaces)
Domain Map Configuration
Chapter 8: T Commands
1347