Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
timers
Syntax
Release Information
Description
Options
Mode
1310
timers update invalid holddown flush
no timers
Command introduced before JunosE Release 7.1.0.
Configures RIP timers. The no version restores the default values.
update—Interval in seconds at which routing updates are sent; default value is 30
invalid—Interval in seconds after which a route is declared invalid (null); default value
is 180
holddown—Interval in seconds during which routing information regarding better paths
is disregarded by the router; default value is 120
flush—Interval in seconds that must pass before a route is removed from the routing
table; set this value greater than the invalid value; default value is 300
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
