JunosE 11.3.x Command Reference Guide N to Z
timeout
Syntax
Release Information
Description
Options
Mode
1308
RADIUS:
timeout waitTime
no timeout
RTR:
timeout timeoutValue
no timeout
Command introduced before JunosE Release 7.1.0.
When used from RADIUS Configuration mode, specifies the interval, in seconds, before
the router retransmits a RADIUS packet to an authentication or accounting server. The
no version restores the default.
When used from RTR Configuration mode, specifies the timeout for a Response Time
Reporter operation. The no version returns the operation to the default value. You can
apply this parameter only to echo entries.
waitTime—Number of seconds in the range 1–1000; default value is 3
timeoutValue—Number in milliseconds that the operation waits for a response; if the
value is set to 0 or is larger than frequency, it will be ignored; default value is 5000
RADIUS Configuration, RTR Configuration
Copyright © 2010, Juniper Networks, Inc.
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 and is the answer not in the manual?
Questions and answers