Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
tunnel destination backup
Syntax
Release Information
Description
Options
Mode
1346
tunnel destination backup [ ipAddress | identity fqdn ]
no tunnel destination backup
Command introduced before JunosE Release 7.1.0.
Configures a backup tunnel destination for the remote IPsec tunnel endpoint. The backup
tunnel is used when the IPSec tunnel destination is detected as unreachable by DPD.
You can use either the IP address or fully qualified domain name (FQDN) to identify the
backup tunnel; however, you must use the same type of identity that is used for the
regular tunnel destination. The no version restores the default, in which the regular tunnel
destination is also the backup tunnel destination.
ipAddress—IP address of the interface on the destination router that serves as the
backup IPSec tunnel endpoint
fqdn—Fully qualified domain name of the interface on the destination router that serves
as the backup IPSec tunnel endpoint; a maximum of 80 characters
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
