Table of Contents
Advertisement
summary-address
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
IS-IS:
summary-address address mask [ level-1 | level-1-2 | level-2 ] [ metric ]
[ tag tagValue ]
no summary-address address mask [ level-1 | level-1-2 | level-2 ]
OSPF:
[ no ] summary-address address mask
Command introduced before JunosE Release 7.1.0.
Creates aggregate addresses for IS-IS or aggregates external routes at the border of the
OSPF domain. The no version restores the default.
address—Summary IP address designated for a range of addresses
mask—IP subnet mask used for the summary route
level-1—Summarizes routes redistributed into level 1; when distributing routes domain
wide, summarizes routes leaked from level 2 into level 1
level-1-2—Summarizes routes redistributed into level 1 and level 2 IS-IS, and routes
leaked between levels
level-2—Summarizes routes learned by level 1 routing into the level 2 backbone with
the configured address/mask value; also summarizes routes redistributed into level 2
IS-IS
metric—Number in the range 1–16777215; the default metric value. The summary uses
this value when advertising the summary address. When no metric is supplied, uses
the value of the lowest-cost route that this is summarizing (default).
tagValue—Number in the range 1–4294967295 that identifies the route tag assigned
to the IS-IS summary address
Router Configuration
Chapter 7: S Commands
1241
Advertisement
Table of Contents
