Srp Switch - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

srp switch

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
srp switch [ [ force ] [ reason ] ]
Command introduced before JunosE Release 7.1.0.
Switches from the primary SRP module to the standby. This command is equivalent to
the redundancy force-switchover command with the srp option. There is no no version.
NOTE: When the high availability state is active, this command does not take
effect until all transaction data, up to when you issue the command, has been
mirrored to the standby SRP module. This behavior preserves legacy behavior
that requires SRP modules to be synchronized before the switchover.
force—Prompts the user to confirm that the router should switch from the primary SRP
module to the standby if the SRP modules are in certain states, such as writing
configuration data to NVS, that could lead to loss of configuration data or corruption
of NVS
reason—Reason for the change
Privileged Exec
Chapter 7: S Commands
1221