Snmp-Server Enable Traps - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

snmp-server enable traps

Syntax
Release Information
Description
Options
1190
To enable and configure trap severity level on a global basis:
[ no ] snmp-server enable traps [ trapCategory | snmp authentication ]
[ trapfilters trapFilter ]
To specify the trap severity level on a per-category basis:
snmp-server enable traps { trapCategory | snmp authentication } per-category-trapFilters
trapFilter
Command introduced before JunosE Release 7.1.0.
ip keyword added in JunosE Release 7.1.0.
packetMirror keyword added in JunosE Release 7.2.0.
per-category-trapFilters keyword added in JunosE Release 9.3.0.
Enables and configures global and category-level SNMP trap generation. The no version
disables SNMP trap generation globally. There is no no version for the command to
specify the trap severity level on a per-category basis.
trapCategory—SNMP trap category
addrPool—Local address pool traps
atmPing—E Series router proprietary ATM ping traps
bfdmib—BFD MIB traps
bgp—BGP state change traps
bulkstats—Bulkstats file full and nearly full traps
cliSecurityAlert—Security alerts traps
dhcp—DHCP traps
dismanEvent—Distributed management (disman) event traps
dosProtectionPlatform—DoS protection platform traps
dvmrp—DVMRP traps
dvmrpProp—E Series router proprietary DVMRP traps
environment—Power, temperature, fan, and memory utilization traps
fileXfer—File transfer status change traps
haRedundancy—High availability and redundancy traps
inventory—Router inventory and status traps
ip—Internet Protocol traps
Copyright © 2010, Juniper Networks, Inc.