Avp - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

avp

avp avpType action
Syntax
no avp avpType
Command introduced in JUNOSe Release 7.2.0.
Release Information
Configures the L2TP tunnel switching behavior for a specified L2TP AVP type. The
Description
no version restores the default L2TP tunnel switching behavior for AVPs of the
specified type.
Options
L2TP Tunnel Switch Profile Configuration
Mode
210
avp
avpType One of the following L2TP AVPs
bearer-type L2TP Bearer Type AVP 18; by default, the router regenerates
this AVP at the outbound LAC session, based on the local policy that is in
effect
calling-number L2TP Calling Number AVP 22; by default, the router
regenerates this AVP at the outbound LAC session, based on the local policy
that is in effect
cisco-nas-port Cisco NAS Port Info AVP 100; by default, the router drops
this AVP
action One of the following actions that characterize the tunnel switching
behavior; currently, only the relay action is supported
relay Causes the router to preserve the value of an incoming AVP of the
specified type when packets are switched between an inbound LNS session
and an outbound LAC session