Closing A Specific Session; Specifying The Number Of Retransmission Attempts; Configuring Calling Number Avp Formats - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

The l2tp shutdown tunnel command and the l2tp drain tunnel command both
affect the administrative state of L2TP for the tunnel. Although each command has
a different effect, the no version of each command is equivalent. Each command's
no version leaves L2TP in the enabled state.

Closing a Specific Session

You use the l2tp shutdown session command to close the specified session.

Specifying the Number of Retransmission Attempts

You can specify the number of retransmission attempts the router uses for tunnels,
in the range 2–30. By default, the router uses a retry count of 5.
Use the established keyword to apply the retry count only to established tunnels.
Use the not-established keyword to apply the retry count only to tunnels that are
not established. If you do not include a keyword, the router applies the retry count
to both established and nonestablished tunnels.
Related Topics

Configuring Calling Number AVP Formats

The E Series LAC generates L2TP Calling Number AVP 22 for incoming-call request
(ICRQ) packets that the LAC sends to the LNS. By default, the E Series LAC generates
the Calling Number AVP 22 in descriptive format.
You can also prevent the E Series LAC from sending the Calling Number AVP in ICRQ
packets.
NOTE: You cannot change the L2TP Calling Number AVP on tunnel switched
interfaces.
To close all existing sessions in a specific tunnel and prevent creation of new
sessions:
host1(config)#l2tp shutdown tunnel 1/isp.com
To close a specific session:
host1(config)#l2tp shutdown session 1/1/1
To configure the number of retransmission attempts:
host1(config)#l2tp retransmission 4 established
l2tp retransmission
Chapter 12: Configuring an L2TP LAC
Closing a Specific Session
343