CMM Commands
show reload
Shows the status of any time delayed reboot(s) that are pending on the switch.
show reload [status | all status]
Syntax Definitions
status
all status
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
It is possible to preset a reboot on a CMM by using the reload command. If this is done, use the show
reload command to see when the next scheduled reboot is going to occur.
•
If the reload from command is used, and a rollback timeout is set, the rollback occurs and is shown
using the show reload command.
Examples
-> show reload status
Primary
Control Module Reload Status: No Reboot Scheduled,
Secondary Control Module Reload Status: No Reboot Scheduled
Release History
Release 7.1.1; command introduced.
Related Commands
reload secondary
reload from
MIB Objects
chasControlModuleTable
chasControlDelayedActivateTimer
chasGlobalControl
chasGlobalControlDelayedResetAll
OmniSwitch CLI Reference Guide
Displays wheter or not either of the CMMs are scheduled for a reload.
Displays wheter or all the modules are scheduled for a reload
Reboots the primary or secondary CMM to its startup software
configuration.
Immediate primary CMM reboot to the specified software configuration
without secondary CMM takeover.
March 2011
show reload
page 37-19