copy running-config working
Copies the running configuration (RAM) to the working directory.
[configure] copy running-config working
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is used to copy the changes made using the CLI commands from the running configura-
tion (RAM) to the working directory.
•
This command is only valid if the switch is running from the working directory. Use the
running-directory
•
This command performs the same function as the
Note. The saved boot.cfg file will be overwritten if the
running-config working
Examples
-> configure copy running-config working
Release History
Release 6.6.1; command was introduced.
page 1-6
command to check from where the switch is running.
or
write memory
commands, in an OmniSwitch set up with redundant CMMs.
write memory
command.
takeover
command is executed after the
OmniSwitch 6250 CLI Reference Guide
CMM Commands
show
copy
November 2009