Adding An Ethernet Service - Cambium Networks PTP 820 Series User Manual

Chapter 6: Ethernet Services and Interfaces
Table 61 Ethernet Services Page Parameters
Parameter
Services ID
Service Type
Service sub type
EVC ID
EVC description
Admin

Adding an Ethernet Service

To add an Ethernet service:
1. Select Ethernet > Services. The Ethernet Services page opens
2. In the Ethernet Services page, click Add. The Ethernet Services – Add page opens.
Definition
A unique ID for the service.
The service type:
•
MP – Multipoint
•
P2P – Point-to-Point
•
MNG – Management
Indicates the type of service (Ethernet).
The Ethernet Virtual Connection (EVC) ID. This parameter does not affect
the network element's behavior, but is used by the NMS for topology
management.
The Ethernet Virtual Connection (EVC) description. This parameter does
not affect the network element's behavior, but is used by the NMS for
topology management.
Indicates whether the service is enabled (Operational) or disabled
(Reserved). You can configure services for later use by defining the
service as Reserved. In Reserved mode, the service occupies system
resources but is unable to transmit and receive data.
phn-3965_006v002
Page 6-4
Configuring Ethernet Service(s)
(Figure 189).