Cambium Networks PTP 820 Series User Manual page 356

Chapter 5: Radio Configuration
Parameter
TSL exceed threshold
seconds
RSL exceed threshold1
seconds
RSL exceed threshold2
seconds
Integrity
To set the Signal Level PM thresholds, click Thresholds. The Signal Level Thresholds Configuration – Edit Page
opens. Set the thresholds, described in
Figure 177 Signal level Thresholds Configuration – Edit Page
Table 53 Signal Level Thresholds
Parameter
RX Level Threshold 1
(dBm)
RX Level Threshold 2
(dBm)
TX Level Threshold (dBm)
Definition
The number of seconds the measured TSL exceeded the threshold during
the interval. TSL thresholds are configured in the Radio Thresholds page.
See Configuring BER Thresholdsand Displaying Current BER.
The number of seconds the measured RSL exceeded RSL threshold 1
during the interval. RSL thresholds are configured in the Radio Thresholds
page. See Configuring BER Thresholdsand Displaying Current BER..
The number of seconds the measured RSL exceeded RSL threshold 2
during the interval. RSL thresholds are configured in the Radio Thresholds
page. See Configuring BER Thresholdsand Displaying Current
Indicates whether the values received at the time and date of the
measured interval are reliable. An x in the column indicates that the
values are not reliable due to a possible power surge or power failure that
occurred at that time.
Table 53, and click Apply.
Definition
Specify the threshold for counting exceeded seconds if the RSL is below
this level.
Specify a second threshold for counting exceeded seconds if the RSL is
below this level.
Specify the threshold for counting exceeded seconds if the TSL is below
this level.
phn-3965_006v002
Page 5-42
Configuring and Viewing Radio PMs and Statistics
BER..