Chapter 15: Configuration Guide (CLI)
Deleting a LAG Group (CLI)
In order to delete a LAG group, you must first make sure that no service points are attached to the LAG group.
To delete a LAG group, simply delete all the members from the LAG, as described above.
Displaying LACP Parameters and Statistics (CLI)
You can display the following LACP parameters and statistics:
•
LACP Aggregation (per LAG)
•
LACP Port Status
•
LACP Port Statistics
•
LACP Port Debug Statistics
Note
PTP 820 does not support any LACP write parameters
Displaying LACP Aggregation Status Parameters (CLI)
To display LACP aggregation status parameters, go to interface view for the LAG and enter the following command:
eth group [lagx]> lacp show status
Table 141 LACP aggregation status parameters
Parameter
Definition
phn-3965_006v002
Page 15-15
Configuring Link Aggregation (LAG) and LACP (CLI)