Cambium Networks PTP 820 Series User Manual page 279

Chapter 4: Unit Management
Figure 128 Remote Networking Configuration – Edit Page
4. Configure the IP parameters of the remote radio, as described in
5. Click Apply, then Close.
Note
To change the Remote IP Address to a different subnet, you must first change the address of the
Remote Default Gateway to 0.0.0.0 and click Apply; then set the Remote IP Address as desired, and
the Remote Default Gateway as desired.
Similarly, to change the Remote IPv6 Address to a different subnet, you must first change the
address of the Remote IPv6 Default Gateway to 0:0:0:0:0:0:0:0 and click Apply; then set the Remote
IPv6 Address as desired, and the Remote IPv6 Default Gateway as desired
Table 35 Remote Networking Configuration Parameters
Parameter
Radio location
Remote radio location
Remote IPv4 Address
Remote Subnet mask
Remote default gateway
Definition
Read-only. Identifies the radio on the local side of the link.
Read-only. Identifies the radio on the remote side of the link.
Enter an IP address for the remote radio. You can enter the
address in IPv4 format in this field, and/or in IPv6 format in the
Remote IPv6 Address field. The unit will receive communications
whether they are sent to its IPv4 address or its IPv6 address.
If you entered an IPv4 address, Enter the subnet mask of the
remote radio.
Enter a default gateway for the remote radio (optional).
phn-3965_006v002
Page 4-4
Configuring the Remote Unit's IP Address
Table 35.