Cambium Networks PTP 820 Series User Manual page 955

Chapter 20: Ethernet Protocols (CLI)
•
local System Cap Supported
on the local system, as included in TLVs transmitted by the LLDP agent. The bitmap is defined by the following
parameters:
o
0 – other
o
1 – repeater
o
2 – bridge
o
3 – wlanAccessPoint
o
4 – router
o
5 – telephone
o
6 – docsisCableDevice
o
7 – stationOnly
o
8 – cVLANComponent
o
9 – sVLANComponent
o
10 – twoPortMACRelay
•
local System Cap Enabled
the local system, as included in TLVs transmitted by the LLDP agent. The bitmap is defined by the following
parameters:
o
0 – other
o
1 – repeater
o
2 – bridge
o
3 – wlanAccessPoint
o
4 – router
o
5 – telephone
o
6 – docsisCableDevice
o
7 – stationOnly
o
8 – cVLANComponent
o
9 – sVLANComponent
o
10 – twoPortMACRelay
To display the local unit's management information, enter the following command in root view:
root> ethernet lldp local-mng-show
The following information is displayed:
•
– The format of the local unit's IP Address. In this release, only IPV4 is supported.
Mng Addr SubType
•
Management Address
•
– Reserved for future use.
Mng Addr Length
•
Mng Addr IF SubType
•
– Reserved for future use.
Mng Addr IF
•
Mng Addr OID – Reserved for future use.
To display the destination MAC address or range of MAC addresses associated with the unit, and their internal
index, enter the following command in root view:
root> ethernet lldp mac-da-table-show
The following information is displayed:
– A bitmap value used to identify which system capabilities are supported
– A bitmap value used to identify which system capabilities are enabled on
– The local unit's IP address.
– Reserved for future use.
phn-3965_006v002
Page 20-32
Configuring LLDP (CLI)