Chapter 3: Configuration Guide
7
Select Radio Unit: Slot 1, Port 3 and click Edit. The RFU/Ethernet Interface Configuration – Edit
page opens.
8
In the Interface Type field, select RFU or Ethernet.
9
Click Apply, then Close.
10
If you configured the port as an Ethernet interface, you must set the port's admin state to Up in
the Interface Manager. See Enabling the Interfaces (Interface Manager). If you configured the port as an
RFU interface, its admin state is Up automatically.
If you configured the port as an Ethernet interface, the port takes the following parameters:
Figure: RFU/Ethernet Interface Configuration Page
Figure: RFU/Ethernet Interface Configuration – Edit Page
phn-3965_006v002
Page 3-83
Configuring Link Aggregation (LAG) and LACP