Cambium Networks PTP 820 Series User Manual page 767

Chapter 16: Unit Management (CLI)
Configuring the Internal Ports for FTP or SFTP (CLI)
By default, the following PTP 820 ports are used for FTP and SFTP when the PTP 820 unit is acting as an FTP or SFTP
client (e.g., software downloads, configuration file backup and restore operations):
•
FTP – 21
•
SFTP – 22
To change the port for either protocol, enter the following command in root view:
root> platform management file-transfer port-config protocol <ftp|sftp>
port-number <0-65535>
To display the ports that are currently configured for FTP and SFTP, enter the following command in root view:
root> platform management file-transfer port-show
These ports are configured globally, rather than per specific operation.
The following sequence of commands displays the current (default) FTP and SFTP port settings, changes the FTP
port to 125 and the SFTP port to 126, and shows the new FTP and SFTP port settings.
root>platform management file-transfer port-show
Port config table:
==================
File transfer
protocol
=====================================
ftp
sftp
root> platform management file-transfer port-config protocol ftp port-
number 125
root> platform management file-transfer port-config protocol sftp port-
number 126
root>platform management file-transfer port-show
Port config table:
==================
File transfer
protocol
=====================================
ftp
sftp
root>
File transfer port
number
21
22
File transfer port
number
125
126
phn-3965_006v002
Page 16-9
Configuring the Internal Ports for FTP or SFTP (CLI)