Cambium Networks PTP 820 Series User Manual page 810

Chapter 17: Radio Configuration (CLI)
Table 163 Aggregate PMs (CLI)
Parameter Description
The number of the interval: 1-30 for daily PM reports, and 1-96 for 15 minute
Interval
PM reports.
Integrity Indicates whether the values received at the time and date of the measured
interval are reliable. "1" in the column indicates that the values are not
reliable due to a possible power surge or power failure that occurred at that
time.
ES Indicates the number of seconds in the measuring interval during which
errors occurred.
SES Indicates the number of severe error seconds in the measuring interval.
UAS Indicates the Unavailable Seconds value of the measured interval. The value
can be between 0 and 900 seconds (15 minutes).
BBE Indicates the number of background block errors during the measured
interval.
Displaying BER Level and Configuring the Excessive BER
Thresholds (CLI)
To display the current BER level, go to radio view and enter the following command:
radio [x/x]>modem show ber
The excessive-ber parameter determines whether or not excessive BER is propagated as a fault and considered
a system event. For example, if
To enable or disable Excessive BER Admin, enter the following command in root view:
root> radio excessive-ber set admin <admin>
Note
By default, Excessive BER Admin is disabled.
To display the current setting for
root> radio excessive-ber show admin
To set the level above which an excessive BER alarm is issued for errors detected over the radio link, go to radio
view and enter the following command:
radio [x/x]>modem excessive-ber set threshold <threshold>
To display the excessive BER threshold, go to radio view and enter the following command:
is enabled, excessive BER can trigger a protection switchover.
excessive-ber
excessive-ber , enter the following command in root view:
phn-3965_006v002
Page 17-21
Configuring and Viewing Radio PMs and Statistics (CLI)