Chapter 2: Getting Started
•
Port speed: 1 GE
•
Media Type: RJ45
•
Auto Negotiation: On
To change these parameters, go to the Physical Interfaces page. See Configuring Ethernet Interfaces.
Note:
Both Eth5 and Eth6 can be configured to either 1 GE or 2.5 GE. The other PTP 820F Ethernet
ports support 1 GE only.
If you configured the port as an RFU interface, make sure to set the Radio Unit parameters as necessary.
•
Configuring Cascading Interfaces (Optional)
•
Configuring the Radio Parameters
•
Entering Radio View (CLI)
•
To view
and configure radio parameters, you must first enter the radio's view level in the CLI.
Use the following command to enter a radio's view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3:
root> radio slot 3 port 1
The following prompt appears:
radio[3/1]>
Reference Guide to Web EMS Menu Structure
phn-3965_006v002
Page 2-4