Cambium Networks PTP 820 Series User Manual page 332

Chapter 5: Radio Configuration
2. Select the carrier and click Edit. The Radio Ethernet Interface Configuration – Edit page opens.
Figure 163 Radio Ethernet Interface Configuration – Edit Page
3. In the Header Deduplication mode field, select from the following options:
o Disabled – Header De-Duplication is disabled.
o Layer2 – Header De-Duplication operates on the Ethernet level.
o MPLS – Header De-Duplication operates on the Ethernet and MPLS levels.
o Layer3 – Header De-Duplication operates on the Ethernet and IP levels.
o Layer4 – Header De-Duplication operates on all supported layers up to Layer 4.
o Tunnel – Header De-Duplication operates on Layer 2, Layer 3, and on the Tunnel layer for packets carrying
GTP or GRE frames.
o Tunnel-Layer3 – Header De-Duplication operates on Layer 2, Layer 3, and on the Tunnel and T-3 layers for
packets carrying GTP or GRE frames.
o Tunnel-Layer4 – Header De-Duplication operates on Layer 2, Layer 3, and on the Tunnel, T-3, and T-4
layers for packets carrying GTP or GRE frames.
4. Click Apply, then Close.
Note
The Utilization threshold field is not applicable.
phn-3965_006v002
Page 5-18
Configuring Header De-Duplication