Cambium Networks PTP 820 Series User Manual page 650

Chapter 11: Access Management and Security
5. In the Password field, enter the password you configured in the FTP server. If you did not configure a
password for your FTP user, simply leave this field blank.
6. If the IP address family is configured to be IPv4, enter the IPv4 address of the PC or laptop you are using as
the FTP server in the Server IP address field. See
Communications.
7. If the IP address family is configured to be IPv6, enter the IPv6 address of the PC or laptop you are using as
the FTP server in the Server IPv6 address field. See
Communications.
8. In the Path field, enter the directory path to which you are uploading the files. Enter the path relative to the
FTP user's home directory, not the absolute path. To leave the path blank, enter //.
9. In the File name field, enter the name you want to give to the exported configuration log.
Note
The directory path and fie name, together, cannot be more than:
If the IP address family is configured to be IPv4: 236 characters
If the IP address family is configured to be IPv6: 220 characters
10. Click Apply, then Close to save the FTP parameters and return to the Configuration Log Upload page.
11. Click Upload. The upload begins.
The File transfer operation status field displays the status of any pending configuration log upload. Possible values
are:
o
Ready – The default value, which appears when no file transfer is in progress.
o
File-in-transfer – The upload operation is in progress.
o
Success – The file has been successfully uploaded.
o
Failure – The file was not successfully uploaded.
The Process percentage field displays the progress of any current configuration log upload operation.
Defining the IP Protocol Version for Initiating
Defining the IP Protocol Version for Initiating
phn-3965_006v002
Page 11-46
Uploading the Configuration Log