Cambium Networks PTP 820 Series User Manual page 145

Chapter 2: Getting Started
Parameter
tx-frequency
local-remote
The following command sets the TX frequency of fixed radio interface 1 to 12900000 KHz, and sets the RX
frequency of the remote unit to the same value.
radio[1/1]>rf set tx-frequency 12900000
The following command sets the TX frequency of fixed radio interface 2 to 12900000 KHz, but does not set the RX
frequency of the remote unit.
radio[1/2]>rf set rx-frequency 12900000 local-remote disable
Configuring the Transmit (TX) Level (CLI)
To set the transmit (TX) level of a radio, enter the following command in radio view:
radio[x/x]>rf set tx-level <tx-level>
To display the maximum transmit (TX) level of a radio, enter the following command in radio view:
radio[x/x]>rf show max-tx-level
Table: Transmit (TX) Level CLI Parameters
Parameter Input Type
tx-level Number
The following command sets the TX level of fixed radio interface 1 to 10 dBm:
radio[1/1]>rf set tx-level 10
Table 22: Transmit (TX) Frequency CLI Parameters
Input
Type
Number
Variable
Permitted Values
-50-34
phn-3965_006v002
Page 2-50
Permitted Description
Values
Depends on The desired TX frequency (in KHz) and, if
the MRMC <local-remote> is set to enable, the desired
script and RX frequency of the remote unit.
RFU type.
enable Optional. Determines whether to apply the
disable configured TX frequency value to the RX
frequency of the remote unit. By default,
the configured TX frequency value is applied
to the RX frequency of the remote unit.
Description
The desired TX signal level (TSL), in dBm.
Entering Radio View (CLI)