Cambium Networks PTP 820 Series User Manual page 165

Chapter 3: Configuration Guide
o
s-tag – A single S-VLAN is classified into the service points.
o
dot1q - A single C-VLAN is classified into the service points.
Note
For a full explanation of Ethernet Services, service types, and attached interface types, see
Configuring Ethernet
5 Click Next. Page 2 of the 1+0 Quick Configuration wizard opens.
Figure 51 1+0 Quick Configuration Wizard (PTP 820G) – Page 2
Figure 52 1+0 Quick Configuration Wizard (PTP 820F) – Page 2
6 In the TX Frequency (MHz) field, set the transmission radio frequency in MHz.
7 In the RX Frequency (MHz) field, set the received radio frequency in MHz.
8 In the TX Level (dBm) field, enter the desired TX signal level (TSL). The range of values depends on the
frequency and RFU type.
9 To mute the TX output of the RFU, select On in the TX mute field. To unmute the TX output of the RFU, select
Off.
Service(s).
phn-3965_006v002
Page 3-7
Configuring a Link Using the Quick Configuration Wizard