Cambium Networks PTP 820 Series User Manual page 880

Chapter 19: Quality of Service (QoS) (CLI)
eth type eth [x/x]>classification set default-cos <default-cos>
To display the default CoS value for an interface, go to interface view for the interface and enter the following
command:
eth type eth [x/x]>classification show default-cos
Table 226 Default CoS CLI Parameters
Parameter Input Type
default-cos Number
The following command sets the default CoS for GbE 1 as 7:
eth type eth [1/1]>classification set default-cos 7
Configuring Ingress Path Classification on a Service Point (CLI)
For instruction on configuring ingress path classification on a service point, see
on a Service Point (CLI).
Configuring Ingress Path Classification on a Service (CLI)
For instruction on configuring ingress path classification on a service, see
Default CoS (CLI).
Permitted Values Description
0 – 7 Enter the default CoS value for frames
passing through the interface. This value
can be overwritten on the service point
and service level.
phn-3965_006v002
Page 19-13
Configuring Classification (CLI)
CoS Preservation and Modification
Configuring a Service's CoS Mode and