Chapter 3: Configuration Guide
1.
Configure the carriers on both ends of the link to the desired frequency channel. Both carriers must be
configured to the same frequency channel.
2.
Assign an XPIC (CCDP operational mode) support-enabled script to the carriers on both ends of the link.
Each carrier must be assigned the same script. For details, refer to
3.
To view
and configure radio parameters, you must first enter the radio's view level in the CLI.
Use the following command to enter a radio's view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3:
root> radio slot 3 port 1
The following prompt appears:
radio[3/1]>
Entering Radio View (CLI)
phn-3965_006v002
Page 3-98
Configuring XPIC