Cambium Networks PTP 820 Series User Manual page 320

Chapter 5: Radio Configuration
Parameter
RX Frequency
Part Number
Serial-Number
Running Software Version
XPIC support
Radio interface
operational status
Operational TX Level
(dBm)
RX Level (dBm)
Modem MSE (dB)
Modem XPI (dB)
Defective Blocks
TX Mute Status
Temperature
Definition
The configured RX radio frequency. The RX radio frequency is configured
in the Frequency control (Local) section of the Radio Parameters page.
See Configuring the Radio Parameters.
The part number of the RFU connected to the radio interface.
The serial number of the RFU connected to the radio interface.
The software version currently running on the RFU connected to the radio
interface.
Indicates whether the RFU supports Cross Polarization Interference
Canceller (XPIC). For instructions on configuring XPIC, see
XPIC.
Indicates whether the radio is operational (Up) or not operational
(Down).
The actual TX signal level (TSL) of the RFU (in dBm).
The actual measured RX signal level (RSL) of the RFU (in dBm).
The MSE (Mean Square Error) of the RX signal, measured in dB. A value of
-9900 (-99.00 dB ) means that the modem is not locked.
The current XPI (Cross Polar Interference) level. The value is valid only
when the modem is locked on a signal.
The number of defective radio blocks that have been counted.
Click Clear Counter to reset this counter.
Indicates whether radio transmission is muted.
The current temperature of the RFU.
phn-3965_006v002
Page 5-6
Viewing the Radio Status and Settings
Configuring