Cambium Networks PTP 820 Series User Manual page 369

Chapter 5: Radio Configuration
Note
To display the same parameters for a specific interval in a separate page, select the interval in the
PM table and click View.
Table 59 Utilization PMs
Parameter
Time interval index
Peak capacity (Mbps)
Average capacity (Mbps)
Seconds exceeding
Threshold
Peak throughput (Mbps)
Average throughput
(Mbps)
Seconds exceeding
Threshold
Integrity
Displaying Frame Error Rate PMs
To display frame error rate PMs per radio or Multi-Carrier ABC group:
1. Select Radio > PM & Statistics > Traffic > Frame error rate. The Frame error rate PM report page opens.
Figure 188 Frame Error PM Report Page
Definition
For 24-hour intervals, displays the date of the interval. For 15-minute
intervals, displays the date and ending time of the interval.
Displays the highest L1 bandwidth, in Mbps, sent through the selected
radio during the measured time interval.
Displays the average L1 bandwidth, in Mbps, during the measured time
interval.
Displays the number of seconds during the measured time interval during
which the L1 bandwidth exceeded 0.
Displays the highest throughput, in Mbps, that occurred for the selected
radio during the measured time interval.
Displays the average throughput, in Mbps, for the selected radio during
the measured time interval.
Displays the number of seconds during the measured time interval during
which the L1 bandwidth exceeded the configured utilization threshold.
Indicates whether the values received at the time and date of the
measured interval are reliable. An x in the column indicates that the
values are not reliable due to a possible power surge or power failure that
occurred at that time.
phn-3965_006v002
Page 5-55
Configuring and Viewing Radio PMs and Statistics