Cambium Networks PTP 820 Series User Manual page 322

Chapter 5: Radio Configuration
Figure 156 Radio Unit Page (PTP 820F)
2. Select the radio unit you want to configure and click Edit. The Radio Unit – Edit page opens.
3. By default, the Admin Status is set to Enable. To disable the RFU, select Disable in the Admin Status field.
4. By default, the Power Admin field is set to Enable. If PoE power is not being used for the RFU connected to
this PTP 820F, select Disable in the Power Admin field.
5. By default, the Media Type field is set to RJ45. If the RFU is connected to the PTP 820F via the PTP 820F
optical (SFP) port, select SFP in the Media Type field.
6. Click Apply.
For a full description of the parameters on the page, see the following table.
Table 44 Radio Unit Parameters
Parameter
Operational Status
Definition
The current status of the IDU-RFU connection.
phn-3965_006v002
Page 5-8
Configuring the IDU-RFU Connection (PTP 820F only)