Cambium Networks PTP 820 Series User Manual page 366

Chapter 5: Radio Configuration
1. Select Radio > PM & Statistics > Traffic > Capacity/Throughput. The Capacity PM report page opens.
Figure 184 Capacity PM Report Page
2. In the Interface field, select the interface that holds the radio for which you want to display PMs.
3. In the Interval Type field:
o
To display reports in 15-minute intervals, select 15 minutes.
o
To display reports in daily intervals, select 24 hours.
To set the thresholds for capacity and throughput PMs:
1. Select Threshold. The Ethernet Radio Capacity & Throughput Threshold page opens.
Figure 185: Ethernet Radio Capacity and Throughput Threshold Page
2. Enter the capacity and throughput thresholds you want, in Mbps. The range of values is 0 to 4294967295.
The default value for is 1000.
3. Click Apply, then Close.
Table 58 describes the capacity and throughput PMs.
Note
To display the same parameters for a specific interval in a separate page, select the interval in the
PM table and click View.
Configuring and Viewing Radio PMs and Statistics
phn-3965_006v002
Page 5-52