Chapter 9: TDM Services and Interfaces
•
Viewing a Tunnel's Operational Status and Attributes
•
Deleting a Tunnel
Viewing Tunnels
To view all the tunnels configured for the unit:
1
Select TDM > TDM PseudoWire > Advanced > PSN Tunnels > PSN Tunnels. The PseudoWire PSN Tunnels
page opens.
Table 105
Figure 328 Pseudowire PSN Tunnels Page
Table 105 Pseudowire PSN Tunnels Parameters
Parameter
Tunnel ID
Tunnel Admin
Tunnel Type
Destination MAC Address
VLAN Type
VLAN ID
Tunnel P-bits
describes the tunnel parameters.
Definition
A unique ID that identifies the tunnel.
Displays the administrative state of the tunnel (Enabled or Disabled).
Displays the tunnel's encapsulation type. In this release, only Ethernet
Layer 2 MEF-8 encapsulation (Eth) is available.
The MAC address of the interface or card at the other site of the link. This
is only relevant for Ethernet (MEF-8) tunnels.
Displays the outer VLAN type used by the tunnel. Options are:
•
None
•
C-type
•
S-type
Displays the VLAN ID assigned to frames passing through the tunnel.
Displays the p-bit value assigned to frames passing through the tunnel.
phn-3965_006v002
Page 9-53
Configuring Advanced Pseudowire Parameters