Cambium Networks PTP 820 Series User Manual page 934

Chapter 20: Ethernet Protocols (CLI)
Parameter
Sub-Ring SP
ERPI Type
MEG Level
Version
Virtual Channel
RPL Owner
Revertive
WTR
Guard Time
Hold-Off Time
SD Handling
West SP SD Capacity
Threshold
East SP SD Capacity
Threshold
Sub-Ring SP SD Capacity
Threshold
Local State
Remote State
Last HP Request
Last Change Time
To display the state of a specific service point, enter the following command in root view:
root> ethernet g8032 show-erpi-sp-state erpi-id <erpi-id> SP <SP>
The following command displays the current state of the East service point for ERPI 1:
Description
The interface to which the ERPI service point that connects the Ring to
the Sub-Ring belongs.
The ERPI type (Ring, Sub-Ring, or Ring with Sub-Ring).
The Maintenance Entity Group (MEG) level used for R-APS messages sent
in the ERPI.
The ERPI (G.8032) protocol version currently being used in the unit.
Reserved for future use.
Indicates whether the ERPI is currently an RPL owner, and if it is, which
ERPI port is the owner.
Indicates whether the ERPI is currently in revertive mode.
The Wait to Restore (WTR) timer.
minutes) the system waits after signal failure before entering revertive
mode.
The minimum time (in msec) the system waits after recovery from a
signal failure before accepting new R-APS messages. The purpose of this
timer is to prevent unnecessary state changes that might be caused by
outdated messages.
The minimum time (in msec) the system waits before reacting to a signal
failure.
Reserved for future use.
Reserved for future use.
Reserved for future use.
Reserved for future use.
The current local state input to the ERPI state machine.
The last event received from the other end of the link.
The last high priority request.
The time of the last ring state transition.
phn-3965_006v002
Page 20-11
This timer sets the minimum time (in
Configuring G.8032 (CLI)