Chapter 14: Getting Started (CLI)
Enabling the Interfaces (Interface Manager) (CLI)
The following are the default settings for the unit's interfaces:
•
Ethernet traffic interfaces, the second management interface, and the Synchronization interface are disabled,
and must be manually enabled as described below.
•
Radio interfaces, the first management interface, and the TDM interface (optional) are automatically enabled.
To enable or disable an interface, enter the following command in root view:
root> platform if-manager set interface-type <interface-type> slot <slot>
port <port> admin <admin>
Note
To enable or disable an E1/DS1 interface, use the
Configuring the E1/DS1 Parameters
Table 131 Interface Configuration CLI Parameters
Parameter
Input Type
interface-type
Variable
slot
Number
port
Number
admin
Variable
The following command enables Ethernet port 1:
root> platform if-manager set interface-type ethernet slot 1 port 1 admin
up
The following command enables an STM-1/OC-3 card in expansion slot 2:
root> platform if-manager set interface-type stm1oc3 slot 2 port 1 admin
up
The following command displays the status of all the interfaces in the unit:
(CLI).
Permitted Values
Description
ethernet
ethernet - An Ethernet interface.
radio
radio - A radio interface
management
management - A management interface.
sync
sync - A synchronization interface.
stm1oc3
stm1oc3 - The STM-1/OC-3interface.
1
Always enter 1.
ethernet: 1-6
The interface you want to enable or disable.
radio: 1-2
management: 1-2
sync: 1
tdm: 1
up
Enter up to enable the interface or down to
down
disable the interface.
phn-3965_006v002
Page 14-22
Enabling the Interfaces (Interface Manager) (CLI)
command. See
pwe3 tdm enable slot