Cambium Networks PTP 820 Series User Manual page 950

Chapter 20: Ethernet Protocols (CLI)
root> ethernet mstp show-port-counters interface <interface> slot <slot>
port <port>
To view the BPDU counters for an interface group, enter the following command in root view:
root> ethernet mstp show-port-counters group <group>
To reset the BPDU counters, enter the following command in root view:
root> ethernet mstp reset-counters
Table 274 Port BPDU Counters CLI Parameters
Parameter Input Type
interface Variable
slot Number
port Number
group Variable
Configuring LLDP (CLI)
Link Layer Discovery Protocol (LLDP) is a vendor-neutral layer 2 protocol that can be used by a network element
attached to a specific LAN segment to advertise its identity and capabilities and to receive identity and capacity
information from physically adjacent layer 2 peers. LLDP is a part of the IEEE 802.1AB – 2005 standard that enables
automatic network connectivity discovery by means of a port identity information exchange between each port
and its peer. Each port periodically sends and also expects to receive frames called Link Layer Discovery Protocol
Data Units (LLDPDU). LLDPDUs contain information in TLV format about port identity, such as MAC address and IP
address.
Permitted Values Description
eth Enter the type of interface:
radio
eth – Ethernet
pwe
radio
pwe – TDM
1
ethernet: 1-6 The interface for which you want to display
radio: 1-2 counters.
management: 1-2
tdm: 1
rp1 To display counters for a LAG group, or a
rp2 Multi-Carrier ABC group, use this parameter
rp3 instead of the interface, slot, and port
rp4 parameters to identify the group. See:
lag1 •
Configuring HSB Radio Protection (CLI)
lag2
•
Configuring Link Aggregation (LAG) and
lag3
LACP
lag4
•
Configuring Multi-Carrier ABC (CLI)
mc-abc1
mc-abc2
mc-abc3
mc-abc4
phn-3965_006v002
Page 20-27
– Radio
(CLI)
Configuring LLDP (CLI)