Cambium Networks PTP 820 Series User Manual page 984

Chapter 21: TDM Services and Interfaces (CLI)
root> pwe3
pwe3> pwe3 pws status show slot 1
====================================================
Slot Number: 1
SW Version: 2.10.18016
Ethernet Source MAC Address: 0:a:25:0:28:e8
Alarms:
Front Panel Clock LOS: cleared
Card Reset: cleared
Configuration Mismatch: cleared
Card Communication Disruption: cleared
Host Communication Disruption: cleared
HW Failure: cleared
LEDs:
Front Panel Clock Output: gray
Front Panel Clock Input: gray
To display the status of a specific pseudowire service, enter the following command in pwe3 view:
pwe3> pwe3 pws status show slot <slot> id <id>
The following is an example of a
output:
root> pwe3
pwe3> pwe3 pws status show slot 1 id 1
====================================================
Slot Number: 1
PW Service Id: 1
Operational Status: down
Transmitted Packets: 83653910
Received Packets: 0
Transitions Normal LOPS: 1
Jitter Buffer Overruns: 0
Max Jitter Buffer Deviation: 900
Current Min Jitter Buffer: 0
Current Max Jitter Buffer: 0
Alarms:
Misconnection: cleared
Loss of Frames: raised
Late Frame: cleared
Malformed Frames: cleared
Jitter Buffer Overrun: cleared
Table 289 Pseudowire Service CLI Parameters
Parameter Input Type
slot Number
id Number
tdm-port Number
pwe3 tunnel status show slot <slot> id <id>
Permitted Values
1
1-16
1-16
phn-3965_006v002
Page 21-23
Configuring TDM Pseudowire Services (CLI)
Description
A unique ID that identifies the service.
The port used with the service.
command and its