Cambium Networks PTP 820 Series User Manual page 812

Chapter 17: Radio Configuration (CLI)
Table 166 RSL Thresholds CLI Parameters
Parameter Input Type
threshold1 Number
threshold2 Number
The following command sets the RSL thresholds to -30 dBm and -60 dBm, respectively.
radio [2/1]>rf pm-rsl set threshold1 -30 threshold2 -60
Configuring TSL Thresholds (CLI)
The number of seconds during which the TX Signal Level exceeds the TSL threshold are counted as TSL Exceed
Threshold Seconds. See Displaying RSL and TSL Levels
To set the TSL threshold, go to radio view and enter the following command:
radio [x/x]>rf pm-tsl set threshold -15
Table 167 TSL Thresholds CLI Parameters
Parameter Input Type
threshold Number
The following command sets the TSL threshold to 10 dBm:
radio [2/1]>rf pm-tsl set threshold 10
Displaying RSL and TSL Levels (CLI)
You can display the RSL (RX Signal Level) and TSL (TX Signal Level) PMs in either 15-minute or daily intervals.
To display RSL and TSL PMs in 15-minute intervals, go to radio view and enter the following command:
radio [x/x]>rf pm-rsl-tsl show interval 15min
To display RSL and TSL PMs in daily intervals, go to radio view and enter the following command:
radio [x/x]>rf pm-rsl-tsl show interval 24hr
The following is the output format of the
Permitted Values Description
-75 - -15 The first RSL threshold (dBm).
-75 - -15 The second RSL threshold (dBm).
(CLI).
Permitted Values Description
-10 - 34 The TSL threshold (dBm).
rf pm-rsl-tsl show
phn-3965_006v002
Page 17-23
Configuring and Viewing Radio PMs and Statistics (CLI)
commands: