Cambium Networks PTP 820 Series User Manual page 537

Chapter 9: TDM Services and Interfaces
•
Port speed: 1 GE
•
Media Type: RJ45
•
Auto Negotiation: On
To change these parameters, go to the Physical Interfaces page. See Configuring Ethernet Interfaces.
Note: Both Eth5 and Eth6 can be configured to either 1 GE or 2.5 GE. The other PTP 820F Ethernet
ports support 1 GE only.
If you configured the port as an RFU interface, make sure to set the Radio Unit parameters as necessary.
Configuring Cascading Interfaces (Optional).
Ethernet interfaces can be any of the unit's Ethernet interfaces. LAGs can also be used.
General Guidelines for Provisioning TDM Pseudowire Services
When provisioning TDM pseudowire services, it is recommended to follow these guidelines:
•
Each service within the same local region should use a unique EC ID. The EC ID should also be unique along the
path of each service.
•
For protected services, the EC ID of the protecting service must be different from the EC ID of the working
service.
•
At one of the two endpoint devices, the Local MEP parameter should be set to 1 while, at the far-end
endpoint device, the Local MEP parameter should be set to 2.
Viewing TDM Pseudowire Services
The TDM PseudoWire Services page
basic parameters.
Note
To filter the list of pseudowire services according to slot or group, select the slot or group in the
Show services for field. Only services with an endpoint in the selected slot or group appear.
Table 100 lists and describes the parameters in the TDM PseudoWire Services page.
(Figure 294) displays the pseudowire services configured on the unit and their
phn-3965_006v002
Page 9-29
Configuring TDM Pseudowire Services