Cambium Networks PTP 820 Series User Manual page 765

Chapter 16: Unit Management (CLI)
To remove an SNMP v3 user, enter the following command in root view:
root> platform security protocols-control snmp v3-authentication remove
v3-user-name <user-name>
To display all SNMP v3 users and their authentication parameters, enter the following command in root view:
root> platform security protocols-control snmp v3-authentication show
Table 149 SNMPv3 CLI Parameters
Parameter Input Type
admin Variable
version Variable
read- Text String
community
write- Text String
community
set-block Variable
v3-user-name Text String
v3-user- Text String
password
v3-security- Variable
mode
v3-encryption- Variable
mode
v3-auth- Variable
algorithm
v3-access- Variable
mode
The following commands enable SNMP v2 on the unit, and set the read community to "public" and the write
community to "private":
Permitted Values
enable
disable
v1
v2
v3
Any valid SNMP read
community.
Any valid SNMP write
community.
yes
no
Must be at least eight
characters.
authNoPriv
authPriv
noAuthNoPriv
None
DES
AES
None
SHA
MD5
readWrite
readOnly
phn-3965_006v002
Page 16-7
Description
Select enable to enable SNMP
monitoring, or disable to disable
SNMP monitoring.
Select v1, v2, or v3 to specify the
SNMP version.
The community string for the SNMP
read community.
The community string for the SNMP
write community.
yes - SNMPv1 and SNMPv2 access is
blocked.
no - SNMPv1 and SNMPv2 access is
not blocked.
A SNMPv3 user name.
A SNMPv3 user password.
Defines the security mode to be used
for this user.
Defines the encryption (privacy)
protocol to be used for this user.
Defines the authentication algorithm
to be used for this user.
Defines the access permission level for
this user.
Configuring SNMP (CLI)