Chapter 5: Radio Configuration
Table 50 MRMC Status Parameters
Parameter
Radio Location
Configured MRMC Script
TX profile
TX QAM
TX bit-rate
RX profile
RX QAM
RX bit-rate
Displaying MRMC PMs
Related Topics:
•
Entering Radio View (CLI)
•
To view
and configure radio parameters, you must first enter the radio's view level in the CLI.
Use the following command to enter a radio's view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3:
root> radio slot 3 port 1
The following prompt appears:
radio[3/1]>
Definition
Identifies the carrier (Slot 2, port 1 or Slot 2, port 2).
The current MRMC script.
The current TX profile.
The current TX modulation.
The current TX bit-rate.
The current RX profile.
The current RX modulation.
The current RX bit-rate.
phn-3965_006v002
Page 5-35
Configuring and Viewing Radio PMs and Statistics