Cambium Networks PTP 820 Series User Manual page 590

Chapter 10: Synchronization
Figure 346 Outgoing Clock Page
2 Select the interface you want to configure and click Edit. The Outgoing Clock – Edit page opens.
Note
You cannot edit the clock source of E1/DS1 interfaces.
Figure 347 Outgoing Clock – Edit Page
3 In the Outgoing clock source field, select the interface's synchronization source. Options are:
o
Local Clock – The interface uses its internal clock as its synchronization source.
o
System Clock – Default value. The interface uses the system clock as its synchronization source.
o
Source Interface – Reserved for future use.
o
Time Loop – Reserved for future use.
4 The Sync Radio Channel field is only relevant for radio interfaces. Select a synchronization channel to use
for interoperability:
o
For interoperability with other PTP 820G or PTP 820F units, use the default value of 0.
o
For non-radio interfaces, use the default value of 0.
Configuring the Outgoing Clock and SSM Messages
phn-3965_006v002
Page 10-7