Cambium Networks PTP 820 Series User Manual page 937

Chapter 20: Ethernet Protocols (CLI)
Configuring MSTP (CLI)
This section includes:
•
Configuring the MSTP Bridge Parameters (CLI)
•
Configuring the MSTP Port Parameters (CLI)
Configuring the MSTP Bridge Parameters (CLI)
This section includes:
•
Enabling and Disabling MSTP (CLI)
•
Defining the Number of MSTIs (CLI)
•
Setting the BPDU Destination MAC Address (CLI)
•
Freezing MSTP (CLI)
•
Resetting the MSTP Stack (CLI)
•
Handling Signal Degrade (SD) Failures (CLI)
•
Setting the Configuration ID (CLI)
•
Mapping Services to MSTIs (CLI)
•
Setting the Bridge Level Spanning Tree Parameters (CLI)
•
Setting and Viewing the Bridge Level MSTI Parameters (CLI)
•
Viewing the MSTP Parameters (CLI)
Enabling and Disabling MSTP (CLI)
Enabling MSTP starts the protocol and sets all port states in all MSTP instances to Blocking. Convergence upon
enabling the protocol generally takes less than two seconds.
Note
All mapping of Ethernet services to MSTP instances (MSTIs) should be performed before enabling
MSTP, For instructions, see
To enable MSTP on the unit, enter the following command in root view:
root> ethernet mstp mstp-enable
Disabling MSTP stops the MSTP protocol from running and sets all ports in all MSTP instances to Forwarding state.
To disable MSTP on the unit, enter the following command in root view:
root> ethernet mstp mstp-disable
To display whether MSTP is currently enabled or disabled on the unit, enter the following command in root view:
root> ethernet mstp show-mstp-enabled
Mapping Services to MSTIs (CLI).
phn-3965_006v002
Page 20-14
Configuring MSTP (CLI)